When replacing the pads for borderless printing,
replace only the ones at the places where soiling occurs
on the paper back side. There is no need to replace all of
the pads for borderless printing.
A
Make sure the printer is turned off and the screen
has turned off, and then unplug the power cable
from the outlet.
B
Leave the printer for a minute.
C
Open the front cover.
D
Prepare the replacement pads for borderless
printing.
There are three types of pads for borderless
printing. The type of pad depends on where the
pads for borderless printing are installed. See the
following for the installation positions.
U “Options and Consumable Products” on
page 152
E
Use tweezers to pull out the pads for borderless
printing that are located at the places where
soiling occurs.
F
Use cleaning sticks to wipe off all ink that has
accumulated at the following three places.
Bottom
Center groove
Sides
G
Bend a new pad for borderless printing.
The bending method varies depending on the
installation position. See the following for the
installation positions.
U “Options and Consumable Products” on
page 152
c
Important:
Do not bend the new pads for borderless
printing at other than the specified place.
SC-P9500 Series/SC-P7500 Series User's Guide
Problem Solver
144
To Next Page
Loading...
General