J
K
Note:
If the roll of media has an outer diameter which is
less than 140 mm, the roll core will not reach the
holder when raised using the lift lever.
Raise it with your hands, and insert the roll core
onto the roll holder.
L
To ensure the roll holder is inserted into the roll
core sufficiently, push it twice.
c
Important:
If the roll holder is inserted into the roll core
insufficiently, media is not fed correctly during
printing because of slippage between the roll
holder and roll core.
This may cause banding in the print results.
M
Tighten the screw until the screw no longer turns.
SC-S80600 Series/SC-S80600L Series/SC-S60600 Series/SC-S60600L Series/SC-S40600 Series User's Guide
Basic Operations
33
To Next Page
Loading...
