I
Insert the two hooks on the flushing pad into the
slots on the printer and press the tab down until
the pad clicks into place.
J
After replacing the flushing pad, press the Z
button.
K
Remove both of the new air filters from the
packaging.
L
Grip the air filters and lift them straight out.
Replace both of the air filters.
M
Place the removed air filters in the packaging that
contained the new air filters.
N
Insert the new air filters.
O
Check that the air filters are installed, and then
press the Z button.
c
Important:
Make sure you install the air filters.
If the printer is used when the air filters are not
installed, sensors may degrade due to mist
causing misalignment in print and the printer
may malfunction.
P
Close the maintenance cover, and then press the
Z button.
Q
A confirmation message is displayed on the
screen. Check the content of the message, select
Yes, and then press the Z button.
Disposing of used maintenance parts U “Disposal” on
page 45
SC-S80600 Series/SC-S80600L Series/SC-S60600 Series/SC-S60600L Series/SC-S40600 Series Operator's Guide
Maintenance
44
To Next Page
Loading...
Need help?
General