When there is lint or dust in the cap
Remove using the tip of the cleaning stick or tweezers.
If no other parts need to be cleaned, proceed to the
following section.
U “Finishing Cleaning” on page 33
When there is lint attached to the
flushing pad
Wipe off lint and dust with the tip of a cleaning stick.
c
Important:
Do not deform the metal section of the top surface. If
they are deformed, they may damage the print head.
If no other parts need to be cleaned, proceed to the
following section.
U “Finishing Cleaning” on page 33
Finishing Cleaning
After cleaning, close the right maintenance cover and
press the Z button.
The menus will close when the print head returns to its
normal position.
To make prints followed by the cleaning, perform
Nozzle Check.
U User's Guide (Online Manual)
Disposing of used ink cleaner, cleaning stick, and
clean-room wipers U “Disposal of used consumables”
on page 45
SC-S80600 Series/SC-S80600L Series/SC-S60600 Series/SC-S60600L Series/SC-S40600 Series Operator's Guide
Maintenance
33
To Next Page
Loading...
Need help?
General