F
Trim the bottom from the upper sheets by
cutting along the line joining the two guides
(the lines above the X marks).
G
Lay the upper sheet on top of the lower sheet.
Lineup the X marks as shown in the illustration
below, and temporarily fasten them using an
adhesive tape on the back.
H
With the two sheets overlapping, trim the
excess by cutting along the line joining the two
cut guides (the lines above the X marks).
SC-T3100M Series/SC-T5100 Series/SC-T3100 Series/SC-T5100N Series/SC-T3100N Series/SC-T2100 Series User's Guide
Printing with the Printer Driver from Your Computer
88
To Next Page
Loading...
Need help?
General