Wireless Network Installation
11
11. Press u or d to select the security mode that your wireless network is using,
then press
OK
.
Note:
If your wireless network doesn’t have security enabled, select None, then
press OK.
12. Do one of the following:
■ If your wireless network uses WPA as the security mode, continue with
“Select WPA Security Settings” on page 12.
■ If your wireless network uses WEP as the security mode, continue with
“Select WEP Security Settings” on page 13.
■ If your wireless network doesn’t have security enabled, continue with
“Confirm Your Network Settings” on page 14.
Network Guide_R1.fm Page 11 Wednesday, April 8, 2009 2:37 PM
To Next Page
Loading...
