16
Wireless Network Installation
Create an Ad-Hoc Wireless Connection
Use this setup method if you want to print wirelessly but do not have an access
point or router.
Important:
For Windows
®
users: If your computer is connected to a network with an Ethernet
cable, you need to disconnect it before installing software. When setup is complete,
reconnect your computer’s Ethernet cable.
For Macintosh
®
users: If your computer is connected to a network with an Ethernet
cable, you cannot set up your printer this way. See “Connect Wirelessly Using the
Setup Wizard” on page 4 or “Wired (Ethernet) Installation” on page 22 to set up your
printer.
1. Press the F
Setup
button on the printer’s control panel.
2. Press l or r to select
Network Settings
, then press
OK
.
3. Press
OK
to select
Wireless LAN Setup
.
Network Guide_R1.fm Page 16 Wednesday, April 8, 2009 2:37 PM
To Next Page
Loading...
