Epson Stylus Photo R280 - Page 101

Epson Stylus Photo R280/R285/R290/Epson Artisan 50/Epson Stylus Photo T50/T59/T60/P50 Revision C
Chapter 4 Disassembly/Assembly 4.5.1 Panel Assy (Disassembly/reassembly procedures of Epson Artisan 50/Epson Stylus Photo T50/T59/T60/P50) 101
Confidential
 Panel Board / Buttons Removal
1. Remove the Panel Assy. (p.67)
2. Remove the two screws on the back of the Panel Assy, and remove the Panel
Cover.
• Screw : C.B.P. M3x10 (tightening torque: 3-5 kgf.cm) (No.4)
3. Remove the screw on the front of the Panel Unit, and remove the Panel Unit
from the Open Sensor Holder by sliding it in the upper right direction.
• Screw : C.B.P. M3x10 (tightening torque: 3-5 kgf.cm) (No.4)
Figure 4-120. Removing the Panel Board / Buttons (1)
4. Disconnect the connector (CN1) on the Panel Board, peel the Panel FFC off
the back of the Panel Shield Plate, and remove the Panel FFC.
5. Remove the two screws and remove the Panel Shield Plate from the Panel
Unit.
• Screw : C.B.P. M3x10 (tightening torque: 3-5 kgf.cm) (No.4)
Figure 4-121. Removing the Panel Board / Buttons (2)
6. Disengage the hook on the back of the Panel Board and remove the Panel
Board.
Figure 4-122. Removing the Panel Board / Buttons (3)
7. Release the three hooks and remove the PS button, the Ink button, and the
Paper button from the Housing Panel B.
8. Slide the Lens of the PS button, the Ink button, and the Paper button in the
direction of the arrow to remove it.
Figure 4-123. Removing the Panel Board / Buttons (4)
[Front side]
Hook of the Panel
Shield Plate
[Back Side]
Panel Unit
Panel Cover
Open Sensor Holder
Panel Shield Plate
[Back Side]
CN1
Panel FFC
Panel Unit[Front side]
Double-sided Tape
Reference Line
Panel Board
Hook
Positioning Hole
and Guide Pin
[Back Side]
Hook
[Back Side]
Housing Panel B
Paper Button
Ink Button
PS Button
Lens
Lens
Step 8
[Front side]
Housing Panel B