Epson Stylus Photo R280 - Page 102

Epson Stylus Photo R280/R285/R290/Epson Artisan 50/Epson Stylus Photo T50/T59/T60/P50 Revision C
Chapter 4 Disassembly/Assembly 4.5.1 Panel Assy (Disassembly/reassembly procedures of Epson Artisan 50/Epson Stylus Photo T50/T59/T60/P50) 102
Confidential
When installing the Panel Unit, be careful of the following:
 When installing the Panel Shield Plate to the Open Sensor
Holder, match the hook and guide pins with the positioning
holes shown in Fig.4-124 and insert the Panel Shield Plate into
the groove of the Open Sensor Holder to secure the Panel
Shield Plate.
Figure 4-124. Installing the Panel Unit
 Attach the Panel FFC with double-sided tape along with the
reference line shown in Fig.4-121 (p.101).
 When installing the Panel Board, match the guide pin with the
positioning hole shown in Fig.4-122.
 Install the PS button, Ink button, and Paper button as shown
in Fig.4-123.
[Upper Side]
Guide Pin and Positioning Hole
Hook and Positioning Hole
Groove
Open Sensor Holder
Panel Shield Plate