Epson Stylus Photo R320 - Transporting the Printer; Related Documentation

To Next Page

To Previous Page

Epson Stylus Photo R320

7/04 Epson Stylus Photo R320 - 11

5. Once the pattern is done printing, examine the first row or

set of lines (marked

#1). Select the line (1-15) in which all

the vertical dots are best aligned. You may need to use a

magnifying glass.

6. Use the and buttons to select the number of that

line (1-15), then press

OK.

7. Repeat step 6 to select the best line for sets #2, #3, and #4.

8. When you’re finished, press

OK.

Transporting the Printer

If you move your printer some distance, you need to prepare it

for transportation in its original box or one of a similar size.

Caution: To avoid damage, always leave the ink cartridges installed

when transporting the printer.

Follow these steps:

1. Turn on the printer, wait until the print head locks in the

far right position, then turn off the printer.

2. Unplug the power cord from the electrical outlet. Then

disconnect the printer cable from the printer.

3. Remove any memory cards from the printer and close the

memory card cover.

4. Remove any paper from the printer, push down the paper

support extension, and close the paper support.

5. Open the printer cover. Secure the ink cartridge holder to

the printer with tape as shown, then close the printer cover.

6. Make sure the CD/DVD tray guide is closed, then push in

the output tray extension and close the tray.

7. Repack the printer and its attachments in the original box

using the protective materials that came with them. See

your Start Here sheet.

Keep the printer level as you transport it.

After transporting the printer, remove the tape securing the

print head and test your printer. If you notice a decline in

print quality, clean the print head (see page 10); if output is

misaligned, align the print head (see page 10).

Other manuals for Epson Stylus Photo R320