Epson Stylus Photo R340 - Page 114

EPSON Stylus Photo R340/350 Revision A
Maintenance Overview 114
<Lubrication Point>
Point shown in the figure of the
Paper Back Lever set in the ASF
Assy.
<Lubrication Type>
G-74
<Lubrication Amount>
Adequate dose
<Remarks>
Use a flux dispenser
<Lubrication Point>
1. Point shown in the figure left.
2. Contacted site of the Paper
Back Lever with the dowel.
<Lubrication Type>
1. G-74
2. G-74
<Lubrication Amount>
Adequate dose
<Remarks>
Use a flux dispenser
Paper Back Lever
Lubrication
Point
Right Side
Lubrication
Point 1
Lubrication
Point 2
Left Side
Lubrication
Point 1
Lubrication
Point 2
ASF Frame
<Lubrication Point>
1. Cam of the LD Roller Shaft
shown in the figure
2. Contact point between cam of
the LD Roller Shaft and the
Paper Back Lever
<Lubrication Type>
1. G-74
2. G-74
<Lubrication Amount>
Adequate dose
<Remarks>
Use a flux dispenser to apply it
<Lubrication Point>
Inside surface of the CR Guide
Plate
<Lubrication Type>
G-26
<Lubrication Amount>
Enough to apply a thin layer of oil
to the area shown by the red line in
the left figure.
<Remarks>
Use a syringe to apply it
LD Roller Shaft
Lubrication
Point 1
Lubrication
Point 1
Lubrication
Point 2
40mm
Lubrication Point
CR Guide Plate
40mm