Epson Stylus Photo R340 - Removing the Right Housing

EPSON Stylus Photo R340/350 Revision A
Disassembly and Assembly Disassembly 44
2.3.3 Removing the Right Housing
 Illustration
Figure 2-5. Removing the Right Housing
 Parts/Components must be removed to remove the Right Housing.
None
 Disassembly Procedure
1. Remove the screw ( ) that secures the Right Housing.
2. Open the Card Slot Cover and release the hooked tab ( ) that secures the
Right Housing.
3. Push the Right Housing toward the rear of the printer to release the ten tabs
( ) and remove the Right Housing.
4. Release the longer leg of the Card Slot Cover Spring from the hooked tab ( )
on the Right Housing and remove the spring.
5. Pull out the lower guide pin ( ) and then the upper guide pin ( ) of the Card
Slot Cover to remove it.
Right Housing
C.B.P 3x8 (6-8kgf.cm)
Hooked Tab
Card Slot CoverLeft Front Side
of the Printer
Hooked Tabs
Right Housing (inside)
Card Slot Cover
Spring
Hooked Tab
Guide
Pins