Epson Stylus Photo R340 - Removing the Rear Housing

EPSON Stylus Photo R340/350 Revision A
Disassembly and Assembly Disassembly 50
2.3.6 Removing the Rear Housing
 Illustration
Figure 2-15. Removing the Rear Housing
 Parts/Components must be removed to remove the Rear Housing.
Paper Support Assy., Left Housing, Right Housing,
Panel Board Assy. (Panel Board and LCD Module), Upper Housing
 Disassembly Procedure
1. Remove the screw ( ) that secures the Rear Cover and remove it.
2. Remove the two screws ( ) that secure the Rear Housing.
3. Slightly lift the Rear Housing to release it from the four tabs ( ), and remove
the Rear Housing.
Rear HousingRear Cover
C.B.S 3x8 (4-6kgf.cm)C.B.P 3x8 (4-6kgf.cm)
C.B.P 3x8 (4-6kgf.cm)
Hooked
Tabs
Hooked
Tabs
1
2
 Tighten the screws to secure the Rear Housing in the order
shown in Figure 2-15.
 Put the two tabs of the Rear Cover into the notches of the frame.
Figure 2-16. Reattaching the Rear Cover
Notches
Tabs