Epson Stylus Photo R340 - Removing the Printer Mechanism

EPSON Stylus Photo R340/350 Revision A
Disassembly and Assembly Disassembly 70
2.3.15 Removing the Printer Mechanism
 Illustration (1)
Figure 2-55. Removing the Printer Mechanism (1)
 Parts/Components must be removed to remove the Printer Mechanism.
Paper Support Assy., Left Housing, Right Housing,
Panel Board Assy. (Panel Board and LCD Module), Upper Housing,
Rear Housing, Main Board Assy., ASF Assy., Shaft Assy. Holder
 Disassembly Procedure
1. Move the Carriage Unit to the center.
2. Remove the three screws ( ) that secure the CD-R Paper Guide and remove
it.
3. Remove the five screws ( ) that secure the Printer Mechanism.
4. Cut the cable tie and release the connector cables.
5. Remove the Upper Ink Eject Porous Pad Support from the Lower Housing.
6. Remove the two pieces of acetate tape and release the connector cable of the
Tray/CD-R Sensor.
C.B.P 3x8 (4-5kgf.cm)
C.B 3x6 (4-5kgf.cm)
CD-R Paper Guide
3
1
2
C.B.S 3x6 (6-8kgf.cm)
5
4
C.B.P 3x8 (6-8kgf.cm)
Main Frame Screw (6-8kgf.cm)
2
Left Side of the Printer
1
3
C.B.P 3x8 (6-8kgf.cm)
Cable Tie
Upper Ink Eject
Porous Pad Support
Right Rear Side of the Printer
Acetate Tape
Tray/CD-R Sensor
Connector Cable
Align the Edge of the Acetate
Tape with the Bend Line.
Right Front Side
of the Printer