Epson Stylus Photo R340 - Page 90

EPSON Stylus Photo R340/350 Revision A
Disassembly and Assembly Disassembly 90
 Reinstalling the Slider Lock Lever
z Make sure that the Slider Lock Lever moves correctly
together with the Cap Slider.
 Reinstalling the Ink System
z Make sure that the Ink Tube is connected at the position
shown in the figure below. Improper connection of the tube
may cause ink leakage.
Figure 2-88. Ink Tube Connection Position
z Check the green line printed on the Ink Tube to make sure
that the tube is not twisted.
z Make sure that the Cap Assy. moves smoothly.
z Make sure that the all gears are correctly set to the shaft of
the Pump Frame and move smoothly.
z Make sure the Pump Assy. is correctly secured.
z Make sure the Ink Tube is free of flattening or compression.
z Face the green line on the Ink Tube in the direction of the
arrow, and attach the tube to the two retainers ( ) on the
bottom of the Cap Frame in the order shown below.
Figure 2-89. Reinstalling the Ink Tube
 Reinstalling the Main Frame Support Plate
z Set the four positioning holes ( ) of the Main Frame
Support Plate onto the guide pins.
z Tighten the screws in the order shown below.
Figure 2-90. Reinstalling the Main Frame Support Plate
The Green Line should
Face This Way
1
2
Positioning Holes
and Guide Pins
C.B.S 3x6
(7-9kgf.cm)
1
2