19
Copying
Follow the instructions in this chapter to use your RX500 as a photocopier, or to
copy with a computer using the Epson Smart Panel software.
■ “Copying Without a Computer” below
■ “Copying With a Computer” on page 28
Copying Without a Computer
1. Open the scanner lid.
2. Place your photo or document face down on the glass, in the upper left corner.
Move your document about 0.1 inch from the top and side edge so your
entire document is scanned.
Note:
If you place your photo flush against the guides, the edges next to the guides may
not be copied.
Move the photo or
document in about
0.1 inch from the edges
Orient the
photo as
shown
To Next Page
Loading...
