Epson Stylus Photo RX500 - Copying With a Computer

28 Copying
Copying With a Computer
Follow these steps to use Epson Smart Panel to copy with your computer.
Note:
Some features, such as PhotoEnhance
™
and Sepia, are only available when copying
from the computer.
1. Press the P On button to turn on the RX500.
2. Open the scanner lid.
3. Place your photo or document face down on the glass, in the upper left corner.
Move your document about 0.1 inch from the top and side edge so your
entire document is scanned.
Note:
If you place your photo flush against the guides, the edges next to the guides may
not be copied.
4. Close the scanner lid.
Move the photo or
document in about
0.1 inch from the edges
Orient the
photo as
shown