Scanning Using the RX500 Buttons 79
If you scanned from an application like Photoshop, your scanned images open
in your application window.
Note:
Some applications don’t support scanning multiple images at once and will only
open one scanned image.
14. Click Close to exit EPSON Scan.
Scanning Using the RX500 Buttons
You can use the buttons on the RX500 to scan an image to your computer or to
send an e-mail with a scanned image attached.
Note:
Both Epson Scan and Epson Smart Panel must be installed on your computer to scan to
your computer or to attach to an e-mail.
Scanning to Your Computer
1. Make sure the RX500 is connected to your computer.
2. Open the scanner lid.
3. Place your photo face down on the glass in the upper left corner. Move it
about 0.1 inch from the top and side edge so the entire photo is scanned.
Note:
If you place your photo too close to the edges of the scanner glass, its edges may
not be scanned.
Move the
photo in about
0.1 inch from
the edges
Orient the
photo as
shown
To Next Page
Loading...
