Scanning Slides and Film 75
2. Remove the film holder from its storage place. (Remember to replace the film
holder when you’re done using it.)
3. If you’re scanning slides, go
to step 5.
If you’re scanning film,
remove the cover from the
film strip holder and slide
your film strip in with the
duller (emulsion) side
facing up. Then replace the cover. (It should snap into place.)
Note:
If you can’t tell which side is duller, look for lettering (Fuji,
®
Kodak,
®
etc.) on the side
of the film. If the lettering is backward, place that side face up.
To Next Page
Loading...
