6
Loading Roll Paper
Attaching the roll paper to the
spindle
When installing the roll paper onto the spindle,
follow the steps below.
1. Slide the movable flange off the end of the
spindle.
2. When attaching roll paper with a 3-inch core,
keep the gray attachments attached.
When attaching the roll paper with a 2-inch
core, remove the gray attachments from the
flange.
Note:
Keep the gray attachments in a safe place for future
use.
3. Place the roll paper on a flat surface so that it
does not unwind. Slide the roll paper onto the
spindle and onto the flange until it fixes into
place.
Note:
Do not stand the spindle when attaching the roll
paper. It may cause slant paper feeding.
4. Slide the movable flange (removed in step 1)
onto the spindle and into the end of the roll
paper until it fixes into place.
Attaching roll paper to the printer
To attach roll paper to the printer, follow the steps
below.
1. Open the roll paper cover.
2. Make sure that the movable flange is fixed into
the end of the roll paper properly.
3. Hold the roll paper spindle so that the black
movable flange is on the left side. Then place
the spindle in the groove located on the top of
the printer.
Black movable flange
To Next Page
Loading...
