8
11. Extend the paper tray and the paper tray cover
according to the paper length to be used for
printing.
12. Press the Paper Source button to select Roll
Auto Cut On on the LCD panel.
c
Caution:
Do not leave the paper in the printer for a long
period of time; its quality will deteriorate. We
recommend that you remove the paper from the
printer after printing.
Loading Cut-Sheet Paper
To load cut-sheet paper in the paper tray, follow
the steps below.
Note:
This section describes loading cut-sheet paper smaller
than A3 size. If you want to load A3 or a larger paper,
or if you want to know the details of paper handling, see
"Paper Handling" in the User’s Guide included on the
Printer Software CD-ROM shipped with your printer.
1. Make sure the printer is on and in the READY
state.
2. Press the Paper Source button to select
Sheet
on the LCD panel.
3. Lift up the paper tray cover, and then pull the
paper guide roller up.
4. Raise the paper guide, and then slide the edge
guide to the left slightly wider than the width
of your paper.
To Next Page
Loading...
