The Control Panel 233
4
4
4
4
4
4
4
4
4
4
4
4
English
11. Examine the printed pattern to determine which set of lines
are aligned (showing the smallest gap), and note the
corresponding number.
12. After the pattern is printed, THICKNESS NUMBER appears. Press
the Paper Feed d button or Paper Feed u button to select
the number noted in step 11, and then press the Enter
button to save the selected value.
13. Press the Paper Source l button.
14. Select CUT METHOD, and then press the Menu r button. Press
the Paper Feed d button or Paper Feed u button to select
STANDARD, THICK PAPER, SLOW, THICK PAPER, FAST, or THIN
PAPER, and then press the Enter
button.
15. Press the Paper Source l button.
16. Select PAPER FEED ADJUST, and then press the Menu r button.
Press the Paper Feed d button or Paper Feed u button to
set the paper feed amount, and then press the Enter
button.
17. Press the Paper Source l button.
18. Select DRYING TIME, and then press the Menu r button. Press
the Paper Feed d button or Paper Feed u button to select
the time in seconds, and then press the Enter
button.
19. Press the Paper Source l button.
20. Select PAPER SUCTION, and then press the Menu r button.
Press the Paper Feed d button or Paper Feed u button to
select STANDARD, -1, -2, -3, or -4, and then press the Enter
button.
21. Press the Paper Source l button.
To Next Page
Loading...
