Maintenance Mode 237
5
5
5
5
5
5
5
5
5
5
5
5
English
Chapter 5
Maintenance Mode
Maintenance Mode
Maintenance mode setting procedure
This section describes how to enter the maintenance mode and
make settings with the buttons on the control panel.
To make the maintenance mode settings, follow the steps below.
Note:
❏ Press the Paper Source l button to return to the previous step.
❏ While you are using the printer in the Maintenance mode, no error
message (if any) appears on the LCD. Therefore, use the
maintenance mode when the printer is in the normal state (no error).
1. Enter the maintenance mode.
Make sure that the printer is turned off. While pressing and
holding the Pause
button, press the Power button to
turn on the printer.
2. Select an item.
Press the Paper Feed d button or Paper Feed u button to
select a desired item.
3. Set the item.
Press the Menu r
button to enter the selected item. The first
parameter is displayed on the LCD.
To Next Page
Loading...
