Epson Stylus Pro 7800 - Setting the Alert Value of the Paper

The Control Panel 235
4
4
4
4
4
4
4
4
4
4
4
4
English
3. Press the Paper Feed d button or Paper Feed u button to
display TEST PRINT, and then press the Menu r
button.
4. Press the Paper Feed d button or Paper Feed u button to
display STATUS SHEET, and then press the Menu r button.
5. Press the Enter
button again to start printing a status sheet.
After printing is finished, follow the message on the LCD to
return to the READY state.
Setting the alert value of the paper
You can get a message when there is not much roll paper left, by
setting the alert value using the steps below.
Note:
This setting is available only when you select ROLL for REMAINING
PPR SETUP in the Maintenance mode. See “REMAINING PPR
SETUP” on page 241 for details.
1. Press the Menu r
button to enter the Menu mode.
2. Press the Paper Feed d button or Paper Feed u button to
display PRINTER SETUP, and then press the Menu r
button.
3. Press the Paper Feed d button or Paper Feed u button to
display ROLL PAPER COUNTER, and then press the Menu r
button.
4. Press the Paper Feed d button or Paper Feed u button to
select the length of the roll paper (between 5 and 99.5 m or 15
and 300 ft), and then press the Enter
button.
5. The screen changes so that you can select the alert value. Press
the Paper Feed d button or Paper Feed u button to select
the alert value (between 1 and 15 m or 3 and 50 ft).