306 Maintenance and Transportation
Note:
❏ If your manual cutter unit has only two holes on each side, use
the lower hole to secure the cutter unit with the screw. Keep the
other two screws and do not lose them.
❏ If you are not using the cutter blade unit, fully slide it to the left
so that it will not damage your print data.
❏ See the Manual Paper Cutter Unit manual shipped with your
Manual Paper Cutter Unit for “Using the Manual Cutter
Unit”.
Removing the Manual Cutter Unit
Remove the manual cutter unit when you transport the printer.
1. Using the screw driver, loosen the screws on the platen.
2. Unhook and remove the cutter from the printer.
3. Secure the four screws you removed on the platen.
To Next Page
Loading...
