LCD screen message Condition/solution
Head Cleaning Set Life Replace the head cleaning set (wiper unit, anti-drying caps, and flushing
pad). Be sure to replace all components at the same time.
Replace head cleaning
set.
Press OK to move
platen back, then start
replacement.
See manual to clean Clean the encoder strip (carriage scale) and replace the air filter.
scale and change air
filter.
USB Memory Error One of the following conditions may have occurred:
Failed to read USB • The USB memory device was removed while the printer was reading the
memory. data
• The selected file is corrupted
• The USB memory device's format type or the file format may not be
supported (FAT32)
Check the light and make sure that the USB memory device is not being
accessed before removing it from the printer.
USB Memory Error One of the following conditions may have occurred:
Failed to write to USB • The USB memory device is damaged
memory.
• The USB memory device was removed while the printer was writing to it
• There is not enough free space on the memory device or the number of
saved files has reached the maximum
Check that the USB memory device is not damaged and that there is enough
free space.
Platen Move Error A foreign object was detected in the platen's path. Check for objects in the
platen's path and under the movable base. If necessary, open the printer
Abnormal platen move
cover to check inside the printer. Then close the printer cover.
detected.
Check platen path and
press the cancel
button
140
To Next Page
Loading...
Need help?
General
