Printing using the Auto Take-Up Reel | 23
3.
Set the Manual switch on the Auto Take-Up Reel to Backward to take up at least three turns of paper
onto the reel. Make sure adequate slack remains between the roll paper and the take-up reel.
Printing using the Auto Take-Up Reel
Once the Auto Take-Up Reel is installed and paper is attached to it, you can use it to take up your prints.
WARNING: Do not touch the Auto Take-Up Reel while it is operating; doing so may result in injury. Turn off the
Auto Take-Up Reel before removing the reel; if the reel operates unexpectedly, bodily injury may occur.
Note: When using the Auto Take-Up reel, make sure Auto Cut is set to Off in the printer driver. Otherwise, a
confirmation message will appear for each print.
1. Set the Auto switch to Forward or Backward, depending on how you set up the paper.
2. Send a print job to the printer. The Auto Take-Up Reel sensor triggers it to take up the slack in the
roll paper 1/4 to 1/2 a turn.