Epson SureColor SC-P5300 - Page 49

1. Access Web Cong and select the Network tab > Wi - Fi D i r e c t .
2. Select Disable for Wi - Fi D i r e c t .
3. Click Next
4. Check the message, and then select OK.
Disabling Wi-Fi from the Control Panel
When Wi-Fi is disabled, the Wi-Fi connection is disconnected.
1. Tap
on the home screen.
2. Select Router.
e
network status is displayed.
3. Tap Change Settings.
4. Select Others > Disable Wi-Fi.
5. Check the message, and then start setup.
6. When a completion message is displayed, close the screen.
e screen automatically closes aer a specic length of time.
7. Close the Network Connection Settings screen.
8. Press the
button.
Disconnecting Wi-Fi Direct (Simple AP) Connection from the Control Panel
Note:
When Wi-Fi Direct (Simple AP) connection disabled, all computers and smart devices connected to the printer in Wi-Fi
Direct (Simple AP) connection are disconnected. If you want to disconnect a specic device, disconnect from the device
instead of the printer.
1. Tap on the home screen.
2.
Select Wi- Fi D i r e c t .
e Wi-Fi Direct information is displayed.
3. Tap Start Setup.
4. Tap Change Settings.
5. Select Disable Wi-Fi Direct.
6. Tap the Disable the settings.
Administrator's Guide
Solving Problems
49