141
• Tracing paper*
• Film
• Blueprints
* When tracing paper is loaded, the product cannot automatically detect the width of the paper. Make
sure you set the Original Size setting on the Copy menu or the Scan Size setting on the Scan menu to
the size of your original.
Caution: Do not load the following types of originals directly in the scanner, or they may cause paper
jams or damage the scanner:
• Originals that are bound
• Originals that are bent
• Originals with carbon backing
• Originals with staples, paper clips, or glue
• Originals with many holes (such as loose-leaf paper)
• Irregularly shaped originals or originals that are not cut at right angles
• Originals with attached photos, stickers, or labels
• Transparent originals
• Glossy originals
• Torn or deteriorated originals
Parent topic: Using the Integrated Scanner
Loading Originals
You can load an original that meets the document specifications in the input slot.
Caution: Do not load photos, valuable original documents, or artwork directly into the product. This may
wrinkle or damage the original.
Note: If the original is curled or creased, straighten or smooth the irregularity before loading the
document into the product. If the original is longer than 39 inches (1 meter), support the document with
your hand or the document support during scanning.
To Next Page
Loading...
