20
TM-L90-i Specifications
.
dpi: dots per 25.4 mm (dots per inch)
*1: 500 mA at maximum for one port. 600 mA at maximum for total of the two ports.
*2: Be sure to use a safety-standards-applied power source that meets the following specifications.
Rated output: 24 V, 2.0 to 10.0 A
Maximum output: 240 VA or less
80 mm paper width 58 mm paper width 40 mm paper width
Print method Thermal line printing
Dot density 203 dpi 203 dpi [dots per 25.4 mm {1”}]
Print width
72 mm {2.84"}, 576 dot
positions
52.5 mm {2.07"}, 420 dot
positions
35 mm {1.38"}, 280 dot
positions
Paper dimensions
79.5 ± 0.5 max. Ф102
mm
{3.13 ± 0.02 4"}
57.5 ± 0.5 max. Ф102
mm
{2.26 ± 0.02 4"}
40.0 ± 0.5 max. Ф102
mm
{1.57 ± 0.02 4"}
Paper type
Normal /
LFC Full Coated
Thermal paper:
NTP080-80
Linerless label paper:
9023 - 0839 (12 roles)
Thermal paper:
NTP058-80
Linerless label paper:
9023-1055 (12 roles)
LFC Lane Coated
Linerless label paper:
9023 –1274 (6 roles)
9023 –1253 (12 roles)
Linerless label paper:
9023 –1823 (12 roles)
9023 –1397 (30 roles)
Linerless label paper:
9023 –1275 (6 roles)
9023 –1257 (12 roles)
Interface
Ethernet
× 1
10BASE-T/100BASE-TX
VGA do not use
USB (host)
× 2
USB 2.0, Type A
5 V, 500 mA*
1
USB (device)
× 1
USB 2.0 High speed, Type B
micro SD card × 1
Drawer kick × 1
Power supply*
2
DC+24 V 7%
Current consumption Approximately 1.8 A
Tem perature
Normal /
LFC Full Coated
Operating: 5 to 45°C {41 to 113°F}
Storage: –10 to 50°C {14 to 122°F} (except for paper)
LFC Lane Coated
Operating: 5 to 35°C {41 to 95°F}
Storage: –10 to 50°C {14 to 122°F} (except for paper)
Humidity
Normal /
LFC Full Coated
10 to 90%
LFC Lane Coated 20 to 80%
Overall dimensions 140 203 148 mm {5.51 7.99 5.83 "} (W D H)
Weight (mass) Approximately 1.9 kg {4.19 lb}