13
5. Align the left edge of the roll paper with the edge of the cover.
6. Close the roll paper cover and tear off the paper with the manual cutter.
Changing the Paper Width
You can change the paper width from 58 mm to 60 mm by removing the spacer
installed in the roll paper holder and changing the setting for the paper width. For
detailed information on changing the paper width, see the TM-P60II Technical
Reference Guide.
Buzzer
The factory default is set to On (buzzer sounds) to indicate the following:
❏ Remaining battery charge is not adequate
❏ Roll paper end
❏ Error
To Next Page
Loading...
