Epson TM-U220 Series Instructions

How to connect an Epson wireless POS printer
http://www.beaglehardware.com/howtowireless.html[3/4/2011 12:28:11 PM]
your IP Address are not 192.168.192, (Ex. 192.168.1), then you need to change your computer's IP address to an
address in the same subnet. Change the IP address to a static IP address. Then make the IP address of the
adapter different than the wireless adapter (like 192.168.192.2). Do not set the computer to the same address as
the wireless adapter on the printer.
4. Disable the computer's wired network adapter (Local Area Connection) if installed (The TMnet utility doesn't seem
to work when there is also a live wired network card enabled)
Making the Initial Connection from the Computer to the Printer
If you are using a wireless adapter installed in a computer to connect with the printer you can now make the initial
connection to the printers.
Open up the View Wireless Networks in the Wireless Adapter properties.
The printer will be visible as EpsonNETIBSS as a "unsecured computer-to-computer network" (with the default settings).
Click on the connection to connect to the printer:
This should establish the connection between the printer and the computer.
Verifying the Connection from the Router to the Printer

Epson TM-U220 Series Specifications

General

Print Method	9-pin, serial impact dot matrix
Autocutter	Partial cut
Weight	Approx. 2.5 kg
Paper Thickness	0.06 to 0.085 mm
Operating Temperature	5 to 45 °C
Interface	RS-232, Bi-directional parallel, USB, Ethernet
Number of Columns	42 columns
Data Buffer	4 KB
Character Set	95 Alphanumeric, 128 x 12 Graphic
Power Supply	AC adapter
Operating Humidity	10% to 80% RH (non-condensing)
Print Speed	4.7 lines per second (at 40 columns, 16 dpi)
Paper Width	76 mm / 69.5 mm / 57.5 mm ± 0.5 mm
Copy Capability	Original + 2 copies