Epson TM200 - Page 13

TM200 Service Manual
- 11 -
DIP switch 1
Note:
TM200 accept ESC/POS command. Dip 1-1 for different printing format, ON(TM200)
for 48 characters per line, OFF(EPSON Emulation) for 42 Characters per line.
Print Density Selection
DIP switch 2
DIP switch Function ON OFF
1-1 Print emulation TM200(default) EPSON Emulation
1-2 Paper near end sensor Vertical Horizontal(default)
1-3
1-4
Selects print density Refer to the table as below
1-5 Cutter setting Disable Enable(default)
1-6 Stop bit Fixed to OFF (1 bit)
1-7 Cutter mode Full Partial(default)
1-8
Reserved: do not change
settin
g
s
Fixed to OFF
Print Density SW 1-3 SW 1-4
1 Low power consumption
mode
ON ON
2 (Normal) OFF(default) OFF(default)
3 ON OFF
4 (Dark) OFF ON
DIP switch Function ON OFF
2-1 Reserved Reserved
2-2 Receive buffer capacity 2K bytes 96K bytes(default)
2-3 Handshaking Fixed to OFF
2-4 Data word length Fixed to OFF (8 bits)
2-5 Parity check Fixed to OFF (None)
2-6 Parity selection Even Odd(default)
2-7
2-8
Transmission speed (See the table below)