Epson TM200 - 1.6 Self-test

TM200 Service Manual
- 12 -
Transmission Speed
DIP switch 3
Note:
In order to connect Serial port, the host setting should be set as:
Data bits 8 bits
Parity check None
Stop bits 1 bit
Flow control (suggest to set for None) None
Transmission Speed
(BPS) – bits per second
SW 2-7 SW 2-8
4800 OFF ON
9600 ON OFF
19200 OFF(default) OFF(default)
38400 ON ON
DIP switch Function ON OFF
3-1 Buzzer1 setting Disable Enable(default)
3-2 Buzzer 2 setting Disable Enable(default)
3-3 ~ 3-8 Undefined - -