Epson TM200 - 1.7 Hexadecimal Dump

TM200 Service Manual
- 13 -
P
a ra ll e l i n te rf ac e mo de l
DIP s w itch 1
Note:
TM200 accept ESC/POS command. Dip 1-1 for different printing format, ON (TM200)
for 48 characters per line, OFF (
EPSON Emulation) for 42 Characters per line.
Print Density Selection
DIP
s w itch 2
DIP s w itch 3
DIP s w itch Function ON OFF
1-1 Print emulation TM200(default) EPSON Emulation
1-2 Paper near end sensor Vertical Horizontal(default)
1-3
1-4
Selects print density Refer to page as below
1-5 Cutter setting Disable Enable(default)
1-6 Parallel port supports EPP SPP/EPP(default)
1-7 Cutter mode Full Partial(default)
1-8
Reserved: do not change
settings
Fixed to OFF
Print Density SW 1-3 SW 1-4
1 Low power consumption mode ON ON
2 (Normal) OFF(default) OFF(default)
3 ON OFF
4 (Dark) OFF ON
DIP s w itch Function ON OFF
2-1 Auto line feed Always enabled Always disabled(default)
2-2 Receive buffer capacity 2K bytes 96K bytes(default)
2-3 ~ 2-8 Undefined - -
DIP s w itch Function ON OFF
3-1 Buzzer1 setting Disable Enable(default)
3-2 Buzzer 2 setting Disable Enable(default)
3-3 ~ 3-8 Undefined - -