22
Initializing
If you become unable to connect to the UB-E04, you can use the following procedure to initialize
settings and restore the device to factory default.
1
Turn off the printer's power.
2
With the push button pressed, turn on the printer's power.
Press the push button with a thin object such as a tweezers.
3
Continue to hold the push button until the initialization start message below is
printed (approx. 10 seconds).
After about 20 seconds, a message notifying the completion of the reset is printed.
After the completion message, a status sheet is printed.
Do not turn the printer's power off until initialization is complete.
To Next Page
Loading...
