Why can't I monitor my Epson Software projector in standby mode?
To monitor and control the Epson projector using EasyMP Monitor when it's in standby mode, ensure the projector's Standby Mode is set to Communication On (or Network On), or that Network Monitoring is set to On within the configuration menu.
What to do if an e-mail message is not sent when a problem occurs with an Epson Software projector?
If you are not receiving email notifications when there's an issue with your Epson projector, verify that the SMTP server IP address, Port Number, and Recipient mail address have all been entered correctly in the settings.
How to fix Epson Software projectors that cannot be monitored or controlled?
If the Epson projector cannot be monitored or controlled, check the following: 1. Ensure the network cable is correctly connected; reconnect if necessary. 2. Verify the Network configuration settings. 3. Reinstall EasyMP Monitor. 4. Register the projectors you intend to monitor or control.
Why is my Epson Software projector not sending e-mail alerts after a critical error?
If your Epson projector has momentarily stopped working due to a critical problem, it won't be able to send email messages. If the projector cannot be reset after checking, contact Epson.
General| Brightness | 3, 300 lumens |
|---|---|
| Contrast Ratio | 15, 000:1 |
| Aspect Ratio | 16:10 |
| Display Type | 3LCD |
| Resolution | 1280 x 800 |
| Native Resolution | WXGA (1280 x 800) |
| Lamp Life | 5000 hours (Normal), 10000 hours (Eco) |
| Connectivity | HDMI, VGA, USB |
| Zoom Ratio | 1.2x |
| Keystone Correction | Vertical: ±30 degrees, Horizontal: ±30 degrees |
| Video Modes | 480i, 480p, 576i, 576p, 720p, 1080i, 1080p |
| Speakers | 2W |
To Next Page
