Start Here
2 Slide the side edge guides all the way out and set the
front edge guide to the paper size you are using.
LT R
3 Insert paper with the glossy or printable side down.
Note: Make sure the paper is loaded against the front edge guide
and not sticking out from the end of the cassette.
4 Slide the side edge guides against the paper, but not too
tightly.
5 Keep the cassette fl at as you insert it all the way.
6 Pull out the output tray and its extensions.
7 Select the paper settings on the product’s control panel.
For more information on loading different paper types or
envelopes, see the online User’s Guide.
Read these instructions before using your product.
The illustrations show the WF-2750, but the steps are the same
for the WF-2760.
Note for Spanish speakers/Nota para hispanohablantes:
Para obtener instrucciones de confi guración en español, consulte
la Guía de instalación en www.epson.com/support/wf2750sp o
www.epson.com/support/wf2760sp (requiere una conexión a Inernet).
1
Unpack
French control panel
stickers
Note: Do not open the ink cartridge packages until you are ready to
install the ink. Cartridges are vacuum packed to maintain reliability.
1 Remove all protective materials from the product.
2 Lift up the scanner unit and remove all protective materials
from inside the product.
3 Lower the scanner unit.
2
Turn on and configure
1 Connect the power cord to the back of the product and to
an electrical outlet.
Caution: Do not connect to your computer yet.
2 Turn on the product.
3 Select your language, country, date, and time.
Note: You can change these settings later using the product’s
control panel. For more information, see the online User’s Guide.
3
Install ink cartridges
1 Lift up the scanner unit.
Caution: Do not touch the fl at, white cable.
2 Gently shake the ink cartridges.
3 Unpack the ink cartridges.
4 Remove only the yellow tape from each ink cartridge.
Caution: Do not remove any other labels or seals, or ink will leak.
Do not touch the green chip on the cartridge.
5 Insert the cartridge in the holder for each color. Press each
cartridge down until it clicks. Make sure all cartridges are
pushed down into place.
6 Lower the scanner unit.
7 The printer starts charging the ink. Ink charging takes
approximately 4 minutes. When you see a completion
message on the printer’s LCD screen, charging is
complete.
Caution: Don’t turn off the printer or raise the scanner unit while
the printer is charging or you’ll waste ink.
Note:
• The printer is designed for use with Epson
®
cartridges only, not
third-party cartridges or ink.
• The cartridges included with the printer are designed for
printer setup and not for resale. After some ink is used for
charging, the rest is available for printing.
4
Load paper
1 Make sure the product is done charging the ink, and then
pull out the paper cassette.
WF-2750/WF-2760
4131631 Rev.0
1-F PMS376U
4131631 Rev.0
1-F K
To Next Page
Need help?
General
