3. Check if the translucent lm is smeared. Smears are easier to see if you use a light.
If there are smears (such as
nger
marks or grease) on the translucent
lm
(A), go to the next step.
A: Translucent
lm
B: Rail
c
Important:
Be careful not to touch the rail (B). Otherwise, you may not be able to print. Do not wipe
o
the grease on the
rail, because this is necessary for operations.
4. Moisten a cotton swab with the water with a few drops of detergent so that it is not dripping water, and then
wipe the smeared part.
c
Important:
Wi f e
o
the smear gently. If you press the cotton swab too hard to the
lm,
the springs of the
lm
may be
dislocated and the printer may be damaged.
User's Guide
Maintaining the Printer
168
To Next Page
Loading...
