Epson WF-2861 - Disconnecting Wi-Fi Direct (Simple AP) Connection from the Control Panel; Restoring the Network Settings from the Control Panel

2. Select Wi-Fi (Recommended).
e network status is displayed.
3. Tap Change Settings.
4. Select Others > Disable Wi-Fi.
5. Check the message, and then start setup.
6. When a completion message is displayed, close the screen.
e screen automatically closes aer a specic length of time.
7. Close the network connection settings screen.
Disconnecting Wi-Fi Direct (Simple AP) Connection
from the Control Panel
Note:
When Wi-Fi Direct (Simple AP) connection disabled, all computers and smart devices connected to the printer in Wi-Fi
Direct (Simple AP) connection are disconnected. If you want to disconnect a
specic
device, disconnect from the device
instead of the printer.
1. Tap on the home screen.
2. Select Wi - F i D i r e c t .
e Wi-Fi Direct information is displayed.
3. Tap Change Settings.
4.
Select Disable Wi-Fi Direct.
5. Tap the Disable the settings.
6. When a completion message is displayed, close the screen.
e screen automatically closes aer a specic length of time.
7. Close the Network Connection Settings screen.
Restoring the Network Settings from the Control
Panel
You can restore all network settings to their defaults.
1. Select Settings on the home screen.
2. Select Restore Default Settings > Network Settings.
User's Guide
Network Settings
41