Epson WF-2861 - Changing the Network Connection to Ethernet from the Control Panel; Disabling Wi-Fi from the Control Panel

Select Change or re-set the connection method on the Select Soware Installation screen, and then click Next.
Changing the Network Connection to Ethernet from
the Control Panel
Follow the steps below to change the network connection to Ethernet from Wi-Fi using the control panel.
1. Select Settings on the home screen.
2. Select General Settings > Network Settings > Wi r e d L AN S e t u p .
3. Tap Start Setup.
4. Check the message, and then close the screen.
e
screen automatically closes
aer
a
specic
length of time.
5. Connect the printer to a router using an Ethernet cable.
Disabling Wi-Fi from the Control Panel
When Wi-Fi is disabled, the Wi-Fi connection is disconnected.
1. Tap
on the home screen.
User's Guide
Network Settings
40