192
Paper Ejection Problems
If you have problems with paper ejecting properly, try these solutions:
• If paper does not eject fully, you may have set the wrong paper size. Cancel printing to eject the paper.
Select the correct paper size when you reprint.
• If paper is wrinkled when it ejects, it may be damp or too thin. Load new paper and be sure to select
the correct paper type setting when you reprint.
Parent topic: Solving Paper Problems
Related references
Paper Jam Problems Inside the Product
Paper Jam Problems in the Cassette
Paper Jam Problems in the Duplexer (Rear Cover)
Paper Type Settings - Control Panel
Related tasks
Cancelling Printing Using a Product Button
Related topics
Loading Paper
Solving PCL/PostScript Problems
Check these sections if you have problems with the PCL or PostScript printer software.
Nothing Prints Using the PCL/Postscript Printer Software
Settings Are Missing from the PCL or PostScript Printer Software
Printing a PS3 (PostScript) Status Sheet
Parent topic: Solving Problems
Nothing Prints Using the PCL/Postscript Printer Software
If your document doesn't print, try these solutions:
• Make sure your product is turned on and properly connected.
• Check your product's control panel for error messages. The PCL and PostScript printing software will
not display any error messages on your computer screen if a printing error occurs.
• Make sure your product is selected as the printer in your printing program.
Parent topic: Solving PCL/PostScript Problems
To Next Page
Loading...
Need help?
General
