Start Here
4 Load paper against the right edge guide and behind the
tab line on the left edge guide, with the printable side
faceup.
Caution: Don’t load the paper sideways; always load it short
edge first.
5 Slide the edge guide against the left edge of the paper,
but not too tightly.
6 Flip the feeder guard back.
6
Connect the fax line
To fax, connect the included phone cord to a telephone wall
jack and to the LINE port on the back of your product. To
connect a telephone or answering machine, use the EXT. port
on your product. See the Quick Guide for more details.
Note: If you’re connecting to a DSL phone line, you must use a DSL
filter or you won’t be able to fax. Contact your DSL provider for the
necessary filter.
Read these instructions before using your product.
Note for Spanish speakers/Nota para hispanohablantes: Para
obtener instrucciones de configuración en español, consulte la Guía de
instalación en www.epson.com/support/wf2530sp (requiere una conexión
a Internet).
1
Unpack
French control
panel stickers
(included for
Canada only)
Caution: Do not open ink cartridge packages until you are ready to
install the ink. Cartridges are vacuum packed to maintain reliability.
Remove all protective materials, including from inside the printer.
2
Turn on
1 Connect the power cord to the back of the printer and to an
electrical outlet.
Caution: Do not connect to your computer yet.
2 Press the power button.
3
Select settings
1 To select English as your language, press OK.
If you want to change the language, press or to
select it, then press OK.
2 Select your country/region and press OK.
3 Select Summer if Daylight Saving Time is in effect;
otherwise, select Winter. Press OK.
4 Select the date format and press OK.
5 Press the number keys to enter the date and press OK.
6 Select the time format (12h or 24h) and press OK.
7 Press the number keys to enter the time. Then press
or to select AM or PM, if necessary.
8 Press OK.
Note: You can change the date and time settings using the printer’s
control panel. For more information, see the online User’s Guide.
4
Install ink cartridges
1 Lift up the scanner unit.
2 Shake the ink cartridges gently 4 or 5 times, then unpack
them.
Caution: Don’t touch the green chip or small window on any
cartridge.
3 Remove only the yellow tape from each cartridge.
Caution: Don’t remove any other seals or the cartridges may
leak.
4 Insert the cartridges in the holder for each color, and
press each cartridge down until it clicks.
5 Lower the scanner unit.
6 Press OK to prime the ink delivery system. This takes
about 5 minutes.
Note: The cartridges included with the printer are designed
for printer set up and not for resale. After some ink is used for
priming, the rest is available for printing only in the same printer.
Caution: Don’t turn off the printer while it is priming or you’ll
waste ink.
Do not press the Wi-Fi Setup button
unless prompted during software installation.
5
Load paper
1 Flip the feeder guard forward.
2 Raise the paper support, pull out the output tray, then
raise the paper stopper.
3 Slide the edge guide to the left.
WF-2530
4123198 Rev.0
1-F C
4123198 Rev.0
1-F M
4123198 Rev.0
1-F Y
4123198 Rev.0
1-F K
To Next Page
Need help?
General
Weight and Dimensions
