5
Install software
Note: If your computer does not have a CD/DVD drive, you can
download the software from the Epson website (see “Epson
technical support”).
Caution: Be sure to close your other programs, including any
screen savers and virus protection software, before beginning
this software installation.
1 Make sure the printer is NOT CONNECTED to your
computer.
Windows
®
: If you see a Found New Hardware screen, click
Cancel and disconnect the USB cable. You can’t install your
software that way.
2 Insert the product CD.
3 Windows 8: Click the CD/DVD drive message that appears
on your computer screen. Then select Run Setup.exe. If
you don’t see this option, navigate to your CD/DVD drive
and double-click Setup.
Windows (other versions): If you see the AutoPlay window,
click Run Setup.exe.
Mac OS X: Double-click the EPSON icon.
4 Windows: If you see the User Account Control screen, click
Yes or Continue.
5 Click Install (Windows) or Continue (Mac OS X) and
follow the instructions on your computer screen.
6 When you see the screen below, check the “Connection
options” section on the back of this sheet for more
information.
Choose your connection. Then click Next (Windows) or
Continue (Mac OS X) and follow the instructions on your
computer screen.
4
Load paper
1 Raise the paper support, pull out the output tray, then
raise the paper stopper.
2 Slide the edge guide to the left.
3 Load paper against the right edge guide and behind the
tab line on the left edge guide, with the printable side
faceup.
Caution: Don’t load the paper sideways; always load it short
edge first.
4 Slide the edge guide against the left edge of the paper,
but not too tightly.
To Next Page
Loading...
