Epson WorkForce WF-M1030 Important Safety Instructions

2 Important Safety Instructions
■ Do not use aerosol products that contain flammable gases inside or around the product. Doing
so may cause fire.
■ Do not touch the flat white cable inside the product.
■ Do not spill liquid on the product. Do not use the product near water. Do not use with wet
hands.
■ Unplug the product and refer servicing to qualified service personnel under the following
conditions: if the power cord or plug is damaged; if liquid has entered the product; if the
product has been dropped or the case damaged; if the product does not operate normally or
exhibits a distinct change in performance.
■ Never disassemble, modify, or attempt to repair any part of the product by yourself, except as
specifically explained in the documentation. Do not adjust controls that are not covered by the
operating instructions.
■ When storing or transporting the product, do not tilt it, stand it on its side, or turn it upside
down; otherwise ink may leak from the cartridge.
Wireless Network Safety
To avoid adversely affecting the operation of the following equipment and causing an accident, do
not use the product: near medical equipment in a medical facility; within 9 inches (22 cm) of a
cardiac pacemaker; near automatically controlled devices, such as automatic doors or fire alarms.
Ink Cartridge Safety
■ Keep ink cartridges out of the reach of children.
■ Be careful when you handle used ink cartridges; there may be ink remaining around the ink
supply port. If ink gets on your skin, wash it off with soap and water. If ink gets into your eyes,
flush them immediately with water. If ink gets in your mouth, spit it out and see a doctor right
away.
■ Do not put your hand inside the product or touch the cartridge during printing.
■ Do not try to move the print head by hand, or you may damage the product.
■ Before transporting the product, make sure the print head is in the home (far right) position
and the ink cartridge is in place.
■ Install a new ink cartridge immediately after removing a used one. Leaving the cartridge
uninstalled can dry out the print head and may prevent the product from printing.
■ Do not shake the ink cartridge too vigorously or after opening their packages; this can cause
them to leak.
■ Be careful not to break the hooks on the side of the ink cartridge when you remove it from the
package.
■ Do not touch the green IC chip or the small window on the side of the cartridge. This may
prevent normal operation.
WF-M1030_notices.fm Page 2 Wednesday, September 5, 2012 2:29 PM

Epson WorkForce WF-M1030 Specifications

Printing Specifications

maximum print resolution	1440 x 720 optimized dpi
maximum print speed	34 ppm
ISO print speed	15.0 ISO ppm
minimum ink droplet size	3 picoliters

Connectivity

standard connectivity	Hi-Speed USB
wireless connectivity	802.11 b/g/n
ethernet connectivity	10/100

Paper Handling

maximum paper size	8.5" x 44"
input paper capacity	100 sheets plain paper, 10 envelopes
duplex printing	manual

Operating Environment

operating temperature	50 ° to 95 °F (10 ° to 35 °C)
storage temperature	-4 ° to 104 °F (-20 ° to 40 °C)
operating relative humidity	20 – 80%

Power

rated voltage	100 – 240 V
rated frequency	50 – 60 Hz
rated current	0.6 Amp

Weight and Dimensions

printing dimensions (W x D x H)	15.4" x 20.9" x 11.7"
storage dimensions (W x D x H)	15.4" x 10.4" x 5.8"
weight	7.1 lb