161
LCD screen message Condition/solution
Cannot change the
setting because Paper
Configuration is
disabled.
The Paper Configuration setting must be enabled to use AirPrint.
The printer's borderless
printing ink pad is
nearing the end of its
service life. Please
contact Epson support.
The ink pads are near the end of their service life and the message will be
displayed until the ink pad is replaced. Contact Epson for support. (To
resume printing, select OK.)
The printer's borderless
printing ink pad has
reached the end of its
service life. It is not a
user-replaceable part.
Please contact Epson
support.
The ink pad is at the end of its service life. Turn off the product and contact
Epson for support.
To use cloud services,
update the root
certificate from the
Epson Web Config
utility.
Access your product's built-in Web Config utility and update the root
certificate for your product.
Paper remains inside
because it is placed
sideways. Load XX size
paper in the XX to
remove the paper inside.
Load letter- or A4-size paper in the rear paper feed and select Done. Load
the removed paper again in the portrait direction, in the center of the rear
paper feed.
The combination of the
IP address and the
subnet mask is invalid.
See your documentation
for more details.
There is a problem with the network connection to your product. Check the
solutions in this guide.
Recovery mode An error has occurred during firmware updating. Connect your product using
a USB cable and try updating the firmware again. If you still receive this error
message, contact Epson for support.
To Next Page
Loading...
