Eqiva UT300 - Operation; Manual Operation; Setting Switch-On and Switch-Off Temperature

26
Operaon
5 Operaon
5.1 Manual operaon
To switch the connected load manually on or o, proceed
as follows:
• Press and hold down the buons „+“ and „–“ at the
same me to exit the automac mode. “Manuell”
(”manual mode”) appears in the display.
• You can manually switch the connected load on and
of with the buons “Aus/Ein” (”o/on”). The current
switching status is shown in the display: “Ein” for “on”
and “Aus” for “o”.
• You can go back to automac mode by pressing „+“ or
„–“. “Auto” appears in the display.
5.2 Seng switch-on and switch-o
temperature
For operaon in automac mode, you can set the switch-on
and switch-o temperature at which the connected device
will be switched on or o. To do this, proceed as follows:
• Make sure if the device is in automac mode (”Auto”
is shown in the display).
• First press the buon “Aus/Ein”(”o/on) briey to
make changes.
• Now select the switch-on temperature with the “+”