Eqiva UT300 - Select Operating Mode Heating or Cooling

27
Operaon
or “-” buons. Press and hold down the buons to
reach the desired value faster.
• Briey press the buon “Aus/Ein”(”o/on”) again.
• Now select the switch-o temperature with the “+”
or “-” buons.
• Briey press the buon “Aus/Ein”(”o/on”) again.
The device is switching back to automac mode. The
display shows the currently measured temperature of the
sensor, the selected operaon mode (”Heizen”/”Kühlen”
for heang or cooling) and the current switching state
(”Aus”/”Ein” for o or on).
5.3 Select operang mode heang or
cooling
Heang
If you want the universal thermostat to work in heang
mode, please select a higher temperature for the switch-o
temperature than for the switch-on temperature.
Example:
Switch-on temperature 15 °C
Switch-o temperature 22 °C
If the temperature falls below the switch-on temperature
(e.g. 15 °C) the heang device will be switched on.