47
EN
Emptying the water tank
In cooling mode, the internal water tank must be emptied regularly. If the display shows "P1", the tank must be
emptied.
Switch o the device and
unscrew the lower cap
Bring the device above a
container and remove the
rubber cap
When the tank is empty,
replace the rubber cap
Screw the cap back on and
restart the appliance.
TROUBLESHOOTING
Malfunctions are often due to minor causes; consult the table below before contacting the after-sales service.
This can save you time and avoid unnecessary expenses.
Problem Causes, solutions
The device does not work
Check the power supply.
Check the fuse.
The remote control does not work Check the battery
The room is not cooled
Check that the "Cooling" mode is active
Check for good air circulation at the inlet and outlet
Check that the filter is clean and not clogged
Check that the setpoint temperature is lower than the ambient temperature
Check that the doors and windows are properly closed
The device vibrates abnormally Check that it is installed on level and stable ground.
The display shows
Empty water tank
The display shows
Please contact After Sales Service
In the event of a persistent problem, contact the after-sales service of your store.
To Next Page
Loading...
