Equinox Systems Fusion 140 - Page 7

www.prolight.co.uk Fusion 140 User Manual
7
Operating instructions
DMX mode:
Operating in a DMX control mode environment gives the user the greatest exibility when it comes
to customising or creating a show. In this mode you will be able to control each individual trait of
the xture and each xture independently.
To access the DMX address mode, press the “MENU” button to show “DMX Address” on the LCD display.
Now press the “ENTER” button and use the “UP” and “DOWN” buttons to set the required DMX address.
Press the “ENTER” button to conrm the setting.
To exit out of any of the above options, press the “MENU” button.
DMX channel mode:
To access the DMX channel mode, press the “MENU” button to show “Channel Mode” on the LCD
display. Now press the “ENTER” button and use the “UP” and “DOWN” buttons to choose one of the 2,
10 or 16 DMX channel modes. Press the “ENTER” button to conrm the setting.
To exit out of any of the above options, press the “MENU” button.
PLEASE NOTE:When the unit is receiving DMX the red DMX indicator on the front panel will illuminate.
10 channel mode:
Channel Value Function
CH1 000-255 Pan adjustment 0-540°
CH2 000-255 Tilt adjustment 0-180°
CH3 000-255 Master dimmer (0-100%)
CH4
000-009 No function
010-255 Strobe (slow-fast)
CH5 000-255 Red (0-100%)
CH6 000-255 Green (0-100%)
CH7 000-255 Blue (0-100%)
CH8 000-255 White (0-100%)
CH9 000-255 Amber (0-100%)
CH10 000-255 UV (0-100%)
Channel Value Function
CH1
000-006 No function
007-037 Show 0
038-068 Show 1
069-099 Show 2
100-130 Show 3
131-161 Show 4
162-192 Show 5
193-223 Show 6
224-255 Show 7
CH2
000-009 No function
010-255
Sound active
(sensitivity low-high)
2 channel mode: